BA 1001/1501/2001 us – Edition 3.3 * 12001b330.fm 3-23
Operation
3.15 Hazard warning system
Pressing switch 39 switches the hazard warning system on and off.
Rotating beacon (option)
The rotating beacon is switched on as soon as the starting key is in position 1.
Observe the legal regulations of your country for operating the rotating beacon.
3.16 Machine travel on slopes
Follow these safety instructions carefully when traveling on slopes, in order to avoid accidents.
Specific safety instructions
☞Tilt in the skip during machine travel.
☞Always travel in low speed on slopes!
☞During machine travel, ensure that you can stop safely any time if the machine starts to
skid or if it becomes unstable.
☞Avoid swiveling the skip downhill on slopes, otherwise the machine can lose its balance
and tip over.
➥Always tilt out the skip uphill.
☞Do not travel across slopes steeper than 20 % otherwise the machine can tip over laterally.
☞Always travel straight ahead when driving uphill or downhill. Driving diagonally or at an
angle to the slope is very dangerous.
☞Travel slowly in meadows, on leaves or wet steel plates. The machine can slip even if
the ground is level.
Fig. 38: Hazard warning system
39
Fig. 39: Rotating beacon on the rollbar
To Next Page
Loading...
