Wacker Neuson 2001 User Manual

5-14 BA 1001/1501/2001 us – Edition 3.3 * * 12001b510.fm
Maintenance
Checking the coolant level
☞Proceed as follows:
• Park the machine on level ground
• Stop the engine!
• Remove the key and carry it with you
• Let the engine and the coolant cool down
• Open the engine cover
• Check the coolant level on the transparent coolant reservoir A and on the radiator B
☞If the coolant level is below the LOW seam or if there is no coolant at the radiator’s
filler inlet:
• Add coolant
Important
Check the coolant level once a day.
We recommend checking it before starting the engine.
Adding coolant
After the engine has cooled down:
☞Release overpressure in the radiator
☞Carefully open the cap to the first notch and fully release the pressure
☞Open filler cap B
☞Add coolant up to the lower edge of the filler inlet (radiator)
☞Close filler cap B
☞Start the engine and let it warm up for about 5 – 10 minutes.
☞Stop the engine
☞Remove the key and carry it with you
☞Let the engine cool down
☞Check the coolant level again
➥The coolant level must be between the LOW and FULL reservoir seams
☞If necessary, add coolant and repeat the procedure until the coolant level remains constant
NOTICE
Do not add a different coolant to the one in the reservoir.
☞Use only the coolant prescribed by Wacker Neuson
– see chapter 5.13 Engine/machine fluids and lubricants (1001 and
1501) on page 5-32
– see chapter 5.14 Engine/machine fluids and lubricants (2001) on
page 5-34.
Important
Check the antifreeze every year before the cold season sets in!
Fig. 83: Radiator
Fig. 83: Coolant reservoir
LOW
FULL
A
B

Wacker Neuson 2001 Specifications

General

Brand	Wacker Neuson
Model	2001
Category	Utility Vehicle
Language	English