BA 357-00 * 3.0 * 35700_05_Bedienung.fm 5-39
Operation 5
In order to avoid hydraulic damage to the machine and/or attachment,
check the flow rate of the attachment before putting it into operation.
► Flow rate indications and consumer pressure on the plug couplings of
the machine
– see chapter 9 “Usable consumer pressure at 3rd control circuit” on
page 9-8.
Important information on connecting the hydraulic control circuits
The hydraulic system of the machine is still pressurized even when the
machine is switched off. This is why the hydraulic plug couplings can be
released; however, they cannot be re-attached if the pressure in the
hydraulic lines has not been released.
► Release the pressure in the system sections before installing or
removing an attachment
– see "Pressure relief – plug couplings" on page 5-33.
See also the Operator’s Manuals of the attachment manufacturers for
installing and operating the attachments.
Hydraulic oil is harmful to the environment!
► When connecting or disconnecting, place a container under the
hydraulic plug couplings.
► Dispose of escaping hydraulic oil by an ecologically safe method.
To Next Page
Loading...