5-60 BA 357-00 * 3.0 * 35700_05_Bedienung.fm
5 Operation
Remove the attachment with hydraulic function from the
KRAMER quickhitch
Damage hazard to the machine and/or the attachment!
► When removing the attachment, always ensure that all hydraulic lines
are disconnected.
If the attachment is placed in direct sunlight after having been taken off,
the oil in the hydraulic cylinders will warm up. This leads to a pressure
increase in the hydraulic cylinders that will make it difficult to attach the
hydraulic lines to the hydraulic connections.
► Set down the attachment out of the sun.
1. Empty the attachment and, if need be, close the multi-purpose bucket,
having released the pressure.
2. Apply the parking brake.
3. Release the pressure in the hydraulic lines of the 3rd control circuit
– see "Pressure relief – plug couplings" on page 5-33.
4. Remove the protective caps from the connections on the quickhitch.
5. Remove the flexible lines A and B from the plug couplings E and F of
the attachment and insert them into the plug couplings of the
quickhitch.
6. Close the plug couplings on the attachment with protective caps.
7. Lower attachments analogously to those without hydraulic function
– see "Remove the attachment without any hydraulic function from the
KRAMER quickhitch" on page 5-58
In order to avoid damage if the attachment tips over, place it on the
ground ensuring stability!
To Next Page
Loading...
Need help?
General
