5-58 BA 357-00 * 3.0 * 35700_05_Bedienung.fm
5 Operation
Remove the attachment without any hydraulic function from the
KRAMER quickhitch
The attachment can tip over after lowering it to the ground!
Can cause serious injury or death.
â–º Lower the attachment to the ground and ensure it cannot tip over.
1. Empty the attachment and drive it to the drop-off position.
2. Align the attachment parallel with the ground. To do this: push the
joystick to the left A.
3. Lower the loader unit until attachment is approx. 5 – 10 cm
(2 – 3.9 in) above the ground. To do this, push the joystick forward C.
Once it is locked, the attachment is secured against unintentional
unlocking. It can only be unlocked from the quickhitch by means of the
two-hand controls.
In order to avoid damage to the attachment lock, follow the order of
unlocking.
4. Unlock the attachment. To do this, press and hold the touch button 59
in the position B.
5. Press the rocker switch 52 on the joystick to the right at the same time
until the lock pins fully come out of the center bores of the attachment.
6. Release switch 52 on the joystick.
7. Release button 59.
8. Slightly tilt the attachment forward.
To do this, press the joystick to the right B.
9. Lower the loader unit. To do this: push the joystick forward C until the
attachment is on the ground without risk of falling over.
10.Reverse the machine away from the attachment.
To Next Page
Loading...
Need help?
General
