Wacker Neuson KRAMER 5055e User Manual

BA 357-00 * 3.0 * 35700_05_Bedienung.fm 5-57
Operation 5
Fit and lock attachments without any hydraulic function to
KRAMER quickhitch
1. Approach the machine to the attachment.
2. Lower the loader unit. To do this: push the joystick forward C.
3. Tilt the quickhitch forward. To do this, press the joystick to the right B.
4. Drive the machine forward until mounts E of the quickhitch are directly
beneath the catch hooks of the attachment.
5. Raise the loader unit until the quickhitch facility engages in the lifting
points of the attachment. To do this, pull the joystick to the rear D.
6. Tilt in the quickhitch completely. To do this, press the joystick to the
left A.
7. Lock the attachment. To do this, press switch 52 in the joystick to the
left in travel direction.
8. Ensure that the attachment is visibly locked on either side with lock
pins F.
Information
Once it is locked, the attachment is secured against unintentional
unlocking. It can only be unlocked from the quickhitch by means of the
two-hand controls– see "Removing an attachment from a SKID STEER
quickhitch" on page 5-64.
Fig. 140
C
B
D
A
52
F
E

Wacker Neuson KRAMER 5055e Specifications

General

Brand	Wacker Neuson
Model	KRAMER 5055e
Category	Front End Loaders
Language	English