5-82 BA 357-00 * 3.0 * 35700_05_Bedienung.fm
5 Operation
Grading
1. Fold up the front half of the bucket.
2. Set the depth of the layer you want to remove with the lift hydraulics.
3. Set the angle of the rear cutting edge.
4. Grade the surface performing forward machine travel.
Drawing material backward
1. Tilt out the multipurpose bucket.
2. Raise the bucket with the lift hydraulics.
3. Fold up the front half of the bucket.
4. Lower the multipurpose bucket to the ground.
5. Set the angle of the bucket.
6. Draw the material driving backward on the surface.
Scraping material
1. Set a flat digging angle.
2. Fold up the front half of the bucket by about 10 to 15 cm (3.9 to 5.9 in).
3. Move off the machine.
➥ The material rolls into the bucket and is picked up at the same time.
This position allows to strip grass turf, for example, down to a thickness of
about 8 cm (3.1 in).
Spreading material
1. Set the rear cutting edge parallel to the ground.
2. Fold up the front half of the bucket until the required quantity of
material is emptied onto the ground.
3. Move off the machine.
4. Lower the multipurpose bucket to the ground.
➥ The rear cutting edge grades the material as it is emptied by
opening the front half of the bucket.
This position allows to spread material without performing machine travel
on the lower layer.
To Next Page
Loading...