BA 357-00 * 3.0 * 35700_05_Bedienung.fm 5-93
Operation 5
Safety instructions on transporting material
The load can tip backward if it is not secured and if
the loader unit is raised!
Can cause serious injury or death.
► Do not transport loads with a raised loader unit.
► During machine travel, always tilt in the attachment a little (towards the
machine) for transport.
► After picking up the load, lower the loader unit to transport position.
Bear in mind the ground clearance!
► Unload material only at machine standstill and do not tilt back the pallet
forks to the limit.
► Secure a bulky load before transporting it.
► Fit the rear of the pallet forks with a protective device.
► Ensure good visibility of the material you want to pick up and of the
work and travel range.
The machine can tip over during machine travel or maneuvers on
slopes with a load on the pallet forks!
Can cause serious injury or death.
► Lower the loader unit to the transport position.
► If possible, travel in reverse with a load on the pallet forks.
The machine can tip over and the load can fall down in conditions of
strong wind and poor visibility with a raised loader unit or fully
loaded pallet forks!
Can cause serious injury or death.
► Avoid high storage positions for material that should
not be exposed to wind.
► Stop fork lift work in conditions of strong wind and poor visibility.
,
To Next Page
Loading...