BA 357-00 * 3.0 * 35700_05_Bedienung.fm 5-95
Operation 5
Fitting attachments from other manufacturers (opt)
Quickhitches for attachments from other manufacturers
• The following quickhitches can be purchased from your dealer and
installed by an authorized service center:
- Quickhitch for EURO attachments
- Quickhitch for SKID STEER attachments
• Important!
Only attachments that have been approved for this use and that
have an approved load diagram may be used with the quickhitch
– see chapter 3 “Attachments for SKID STEER quickhitch (currently
not available)” on page 3-21 Attachments for EURO quickhitch on
page 3-23.
• If other attachments are used, conformity (stability test) in accordance
with the EC machine guideline or the DIN EN 474-3 standard must be
checked and documented by an authorized service center.
In the case of non-EU countries, follow and apply the national
regulations of these countries.
• Refer to the following information sheets on page 5-97 "Stability calcu-
lations for attachments from other manufacturers" for the stability test.
• Warranty and the operation license become void if non-approved
attachments are installed, or if parts of the quickhitch or attachment
(with a prescribed condition or quality, or the operation of which can
put persons at risk) are subsequently modified or replaced.
• In addition to the Operator’s Manual, observe and instruct the operator
in all other generally applicable, legal and other mandatory regulations
relevant to accident prevention and environmental protection.
To Next Page
Loading...
Need help?
General
