BA 357-00 * 3.0 * 35700_03_Einleitung.fm 3-21
Introduction 3
Attachments for SKID STEER quickhitch (currently not available)
Important information on the quickhitch facility and attachments
The SKID STEER quickhitch can only be installed in connection with the
standard loader unit.
The machine manufacturer has only certified and released the
attachments listed on page 3-22 for this quickhitch!
In order to ensure machine stability, and to avoid damage to the loader
unit:
► Use only attachments that are certified for the existing quickhitch and
loader unit, and that are fitted with a load diagram certified for the
specific attachment.
► If uncertified attachments are installed, or if parts of the quickhitch or
attachment are subsequently modified or replaced, the operation
licence and the warranty become void.
► In addition to the Operator’s Manual, observe and instruct the operator
in all other generally applicable, legal and other mandatory regulations
relevant to accident prevention and environmental protection.
► Please contact your dealer if you require more information on the
quickhitch and the specific attachments.
If other attachments are installed and used, conformity (stability test) in
accordance with the EC machinery directive or the EN 474-3 standard
must be checked and documented by an authorized service center
– see chapter 5 “Fitting attachments from other manufacturers (opt)” on
page 5-95.
Remove attachments that are not certified for machine travel on public
roads in Germany, load them on a separate transport vehicle and
transport them to the job site.
Get informed on and follow the legal regulations of your country.
To Next Page
Loading...
Need help?
General
