BA 357-00 * 3.0 * 35700_07_Wartung.fm 7-45
Maintenance 7
Battery installation and removal with crane
Safety instructions for installation and removal
The battery may only be replaced by people who
are trained on the vehicle.
The battery is firmly installed in a battery tray. The entire battery tray is
replaced when replacing the battery.
Accident hazard when installing and removing the battery!
Risk of bruising, pinching or crushing when installing and removing the
battery because of weight, as well as chemical burns from battery acids
are a hazard.
► See section "Safety instructions for handling the battery on page 7-31".
► Wear protective clothing when installing and removing the battery.
► Only use batteries with insulated cells and insulated end-posts that
have been approved by the manufacturer.
► Park the machine in a horizontal position to prevent the battery from
slipping out.
► Only change the battery using crane gear that has been tested and is
sufficiently able to carry the load.
► Do not damage the battery when installing or removing it.
► Take care to ensure the battery is firmly seated in the battery
compartment of the machine.
Crushing hazard!
There is a risk of crushing when replacing the battery.
► When replacing the battery, to not reach between the battery and the
frame.
► Wear safety glasses and protective clothing.
In order to avoid damage to the vehicle electronics, only use batteries
approved by the vehicle manufacturer
– see chapter 9 “Light bulbs” on page 9-9!