BA 357-00 * 3.0 * 35700_07_Wartung.fm 7-69
Maintenance 7
The road traffic module is installed under the operator seat.
The fuses are located under the cover A of the road traffic module.
Fuse assignments – see chapter 9 “Road traffic module” on page 9-13.
Removing a fuse
1. Lower the loader unit.
2. Apply the parking brake.
3. Actuate the motor isolating switch.
4. Turn the machine off and remove the ignition key.
5. Open the battery cover plate.
6. Disconnect the battery connector.
7. Folding the operator seat forwards.
8. Unscrew the fastening screws of the cover.
9. Take off cover A from the fuse box.
10.Remove the defective fuse.
Installing a fuse
1. Insert the new fuse.
➥ Descriptions and output indications
– see chapter 9 “Fuses” on page 9-11.
2. Close the fuse box again.
3. Fold back the operator seat and re-secure it.
4. Connect the battery connector.
5. Close the battery cover plate.
6. Turn on the machine.
7. Check the electrical system for correct function.
To Next Page
Loading...