219
W&T Appendix
Subject to error and alteration
Now turn the Com-Server on and off to reset it and while it is
starting up hold down the „x“ key (lower case, no Caps Lock!).
After about 2-3 seconds the prompt IP no.:+<ENTER>: will ap-
pear in the terminal window.
Now enter the IP address you want to assign in the usual dot
notation (e.g. 172.17.10.10). There will be no immediate echo
of characters, so the individual inputs will not be seen on the
monitor. Only after you have pressed Return to confirm is the
completely entered IP address returned by the Com-Server.
Each separated by a comma, this method can also be used to
assign subnet mask and gateway address.
Example 1
Assigning only the IP address:
172.15.222.5 <ENTER>
Example 2
Assigning IP address, Subnet Mask, Gateway:
172.15.222.5,255.255.0.0,172.15.222.1 <ENTER>
Example 3
Assigning IP address, Subnet Mask, Gateway and activating
Web Based Management on TCP port 80:
172.15.222.5,255.255.0.0,172.15.222.100+80 <ENTER>
1
To avoid unintended changes to the IP address, the
DHCP client of the Com-Server is automatically deactiva-
ted when configuring using the serial port.
1
If you have made improper entries or typing
mistakes, the Com-Server will return FAIL followed by
its actual current IP address. The procedure must then be
repeated.
To Next Page
Loading...
