W&T Com-Server++ - Page 54

54
W&T Configuration access to the Com-Server
n
The Abort button causes the Com-Server to reject all the
settings you made and quits the configuration session.
n
The Restore Defaults button resets the Com-Server to its
original factory setting. All settings including the network
parameters IP address, subnet mask and gateway address
are lost.
n
The Firmware Update button activates the mode in which
the Com-Server expects a firmware update via TFTP pro-
tocol (see section Firmware Update of the Com-Server).
Update mode can be exited only by complete transmission
of a valid firmware or by interrupting the supply voltage.
When using the WuTility tool for the firmware update, this
mode is automatically started. In this case a manual start
is not necessary.
n
Restarts the Com-Server, comparable with interrupting the
supply voltage. Data from any other opened connections
to the Com-Server are lost in this event.
1
The functions located on the logout page of the
Com-Server can also be found in the Telnet menu branch
SETUP System r Setup TCP/IP.