Unpacking and Inspecting 1
Chapter 1
Unpacking and Preparing
Your System
This chapter describes how to unpack and prepare your Waters
®
600E Multisolvent
Delivery System for installation.
1.1 Unpacking and Inspecting
The Waters 600E Multisolvent Delivery System is shipped in two containers. System
components include:
• 600 controller (electronics unit)
• 600E pump and startup kit
Save the shipping cartons in case you need to transport or ship a component later.
Accessories
Accessories such as columns, column heater, data systems, autosamplers, detectors, and
system rack are packed separately. Save the shipping cartons in case you need to transport
or ship one of these components in the future.
Procedure
1. Remove the packing material from the cartons.
2. Grasp the units from the bottom and lift straight up and out
3. After unpacking the system and the associated parts, check the contents against the
packing slip to confirm that all items are included.
4. Inspect all items for damage.
Caution: Lifting most units requires two people.
To Next Page
Loading...
