Maintenance Considerations 57
Chapter 4
Maintenance Procedures
This chapter describes maintenance procedures you can perform to ensure the Waters
600E Multisolvent Delivery System consistently provides accurate and precise results.
4.1 Maintenance Considerations
Safety and Handling
Cleaning
Use a damp soft cloth to clean the outside surface of the instrument.
When performing maintenance procedures on your 600E system, keep the following
safety considerations in mind:
Caution: To prevent the possibility of electric shock, never disconnect an electrical
assembly (including the pump interface cable) while power is applied to the Waters 600E
system.
STOP
Attention: To prevent damage to the 600 controller, wait approximately three minutes
once power is disconnected before removing an electrical assembly (including the pump
interface cable).
Caution: When handling eluents, changing tubing, or operating the 600E system in
general, always observe good laboratory practices. Know the physical and chemical
properties of the eluents. Refer to the Material Safety Data Sheets for the eluents in use.
STOP
Attention: Do not touch integrated circuit chips or other components that do not
specifically require manual adjustment. Damage due to static electricity could occur.
To Next Page
Loading...
