Watlow CLS200 - Page 10

CLS200 Series User’s Guide
10
Table 5.4 — Application Example: Setting Up Remote Setpoint 112
Table 5.5 — Application Example: Setting Up Differential Control 114
Chapter 6: Ramp/Soak—115
Table 6.1 — Ramp/Soak Specifications 116
Table 6.2 — Trigger Latch Logic 123
Table 6.3 — Display Formats 124
Table 6.4 — Ramp/Soak Single Loop Display 125
Table 6.5 — Ramp/Soak Control Status Symbols 126
Table 6.6 — Ramp/Soak Profile Modes 129
Chapter 7: Turning and Control—131
Table 7.1 — Proportional Band Settings 136
Table 7.2 — Integral Term and Reset Settings 137
Table 7.3 — Derivative Term Versus Rate 137
Table 7.4 — General PID Constants 138
Chapter 8: Troubleshooting and Reconfiguring—139
Table 8.1 — Controller Alarm Codes for Process and Deviation Alarms 140
Table 8.2 — Operator Response to Alarms 141
Table 8.3 — Failed Sensor Alarm Codes 141
Table 8.4 — Hardware Error Messages 142
Table 8.5 — Other Symptoms 142
Table 8.6 — Resistor Values for Current Inputs to Four-Loop and Eight-Loop Controllers 155
Table 8.7 — Resistor Locations for Current Inputs to Four-Loop and Eight-Loop Controllers 155
Table 8.8 — Resistor Values for Voltage Inputs to Four-Loop and Eight-Loop Controllers 155
Table 8.9 — Resistor Locations for Voltage Inputs to Four-Loop and Eight-Loop Controllers 156
Table 8.10 — Resistor Values for RTD and Thermistor Inputs to Four-Loop and Eight-Loop Controllers 156
Table 8.11 — Resistor Locations for RTD and Thermistor Inputs to Four-Loop and Eight-Loop Controllers 156
Table 8.12 — Resistor Values for Current Inputs to Sixteen-Loop Controllers 157
Table 8.13 — Resistor Locations for Current Inputs to Sixteen-Loop Controllers 157
Table 8.14 — Resistor Values for Voltage Inputs to Sixteen-Loop Controllers 158
Table 8.15 — Resistor Locations for Voltage Inputs to Sixteen-Loop Controllers 158
Chapter 9: Linear Scaling Examples—159
Table 9.1 — Input Readings 159
Table 9.2 — Scaling Values 159
Table 9.3 — Input Readings and Calculations 160
Table 9.4 — Scaling Values 160
Table 9.5 — Scaling Values 161
Chapter 10: Specifications—162
Table 10.1 — Agency Approvals / Compliance 162
Table 10.2 — Environmental Specifications 162
Table 10.3 — Physical Dimensions 162
Table 10.4 — Processor with Standard SCSI Cable 163
Table 10.5 — Processor with Right Angle SCSI Cable 163
Table 10.6 — Processor Connections 164
Table 10.7 — TB50 Physical Dimensions 164
Table 10.8 — TB50 Connections 165
Table 10.9 — TB50 with Straight SCSI Cable 165
Table 10.10 — TB50 with Right Angle SCSI Cable 166
Table 10.11 — Analog Inputs 166