Wavetek 75 - RS-232-C Option 002 Diagram

OPTION .A27
INSTRUMENT COVERS NOT SHOWN
r
W8 - FORM APPROXIMATELY
AS SHOWN
THIS DOCU~EN-T CONTAINS mornInmv IN-
MATION AND DUlON RWTS BELONOIIIO TO
WAVETEK AND MAY NOT BE IIWRODUCED ron ANY
RW EXCEPT CALUMTICU. WERATION. *H)
MAINTENANCE WIlHDUl WRITTEN AWRIZATYYI.
5 BAUD RATE SELECTOR SWITCH FACTORY PRESET
TO
%OO BAUD,
SEE
INSTRU~NT INSTRUCTION PANIJAL,
IF OPTION INSTALLED ON MODEL B, EXCEPT
MODEL 23 SPECIAL, DO NOT USE LABEL UOO-Ol-%lom
INSTALL RS-B2C CABLE/ALlGNMENT FIXTURE TO J29
WHILE TIGHTENING HARDWARE TO ENSURE CORRECT SPACING,
2.
REFERENCE DESIGNATORS
DO NOT APPEAR ON PARTS,
1,
FOR UNIT INTERCONNECTION SEE INSTRUMENT SCHEMATIC.
WOTE UNLESS OTHERWlS€ PECIfIED
(AsSY, POWER SUPP
RmRENCE DESIONATDRS
PART DEBCRIPTION
ORIQ-MFOR-PMT-NO MFOR UAIlETEll NLl QNRT
NON ACCEPTANCE TEST 23/75-0427 YVTK 0007-00-0427 1
SPECIFICATION
PCA. R8-232 OPTION 1100-00-1677 UVTW
1100-00-1677 1
2
PLATE, RS-232 ADAPTER 23/75-9643 UVTU 1400-01-9643
1
3
~XIDIFICATIDNI JACK 23/75-9669 UVTK
1-01-9669 2
BCREU
UVTW 1400-01-9WO 1
MARK LABEL
FOR OPTION 002 3
'
SCREW. 4-40X3/160 PHP, N 4-40 X 3/16
CPRCL a800-23-4103 4
YLW PATCH
'dl3 ASSVI RIBBDN CABLE -2-0- UVTU 6WZ-OO4ca9 1
WAV~T~K
*OIIEMBLV No.
1000-40-0427
OPTION 002 RS-232C INTERFACE
PWrrSUST
FOR MODEL 2-75
PmE 1
SPLIT LOCK WASHER
FLAT WASHER
JACK SCREW
REAR PANEL
OPTION 002
NOTE UNLESS OTHERWISE SPECIFIED
HARDWARE KIT
DETAIL 'B" \JIG
(NOT TO SCALE)
WAVEFORM GENERATOR