Wavetek 75 - Contents

CONTENTS
SECTION 1 GENERAL DESCRIPTION
1.1 MODEL 75 ................................................. 1-1
........................................
1.2 WAVEFORM EDITING 1-1
.......................................
1.2.1 Standard Waveforms 1-1
......................................
1.2.2 Rubber Band Editing 1-1
............................
1.2.3 Digital Amplitude and Digital Offset 1-1
1.2.4 Point Edit
................................................ 1-1
......................................
1.3 STANDARD FEATURES 1-1
........................
1.3.1 81 92 x 4095 Point Waveform Resolution 1-1
................................
1.3.2 Crystal Controlled Frequency 1-1
..........................................
1.3.3 Operating Modes 1-1
..................................
1.3.4 Internal Waveform Counter 1-1
1.3.5 Hold Function
............................................. 1-1
...........................................
1.3.6 Return Function 1-2
.........................................
1.3.7 Stored Waveforms 1-2
...............................
1.3.8 Non-Volatile Instrument Set-Up 1-2
...........................................
1.3.9 Series Operation 1-2
.........................................
1.3.1 0 Parallel Operation 1-2
...................................
1.3.1 1 Communications Options 1-2
...........................................
1.4 SPECIFICATIONS 1-2
.......................................
1.4.1 Standard Waveforms 1-2
..........................................
1.4.2 Operational Mode 1-2
.......................................
1.4.3 Waveform Resolution 1-2
..............................................
1.4.4 Sample Rate 1-2
............................................
1.4.5 Output Signals 1-3
......................................
1.4.6 Output Characteristics 1-3
...................................................
1.4.7 Inputs 1-3
1.4.8 Trigger Sources
........................................... 1-3
..............................
1.4.9 Communication Ports (Optional) 1-4
................................................
1.4.10 General 1-4
1.4.11 Options
................................................. 1-4
SECTION 2 INITIAL PREPARATION
....................................
2.1 UNPACKING INSPECTION 2-1
..................................
2.2 ELECTRICAL INSTALLATION 2-1
.........................................
2.2.1 Power Connection 2-1
...................................
2.2.2 Verifying the Line Voltage 2-1
..................................
2.2.3 Fuse and Voltage Selection 2-2
.......................................
2.2.4 Signal Connections 2-3
......................................
2.2.5 Interface Connections 2-3
.............................................
2.2.6 GPlB Address 2-4
......................
2.2.7 RS-232 Baud Rate and DTElDCE Selection 2-4
..............................
2.2.8 Connecting the RS-232 Interface 2-5
..............................
2.3 INITIAL CHECKOUT PROCEDURE 2-7
Scans by Artekhledia O 2006