Wavetek 75 - Table of Contents

CONTENTS (Continued)
SECTION 3 OPERATION
... ......
3.1 INTRODUCTION ......... ........... 3-1
....
3.2 CONTROLS, CONNECTORS. AND INDICATORS .......... 3-1
.................................
3.3 OPERATION ...... 3-7
.......
3.4 INITIAL SETUP ...... ................... 3-7
................................
3.5 EDITING WAVEFORMS 3-7
...........................
3.6 THUMBTACKS AND CURSOR 3-8
...........................
3.7 RUBBER BAND EDITING 3-8
3.8 INSERTING STANDARD WAVEFORMS
................ 3-8
3.9 DIGITAL AMPLITUDE
............................... . . 3-8
...... ......... 3.1 0 NORMALIZING ...... . 3-8
.....
3.11 DIGITAL OFFSET ............................. 3-8
........................................
3.1 2 POINT EDITING 3-8
.............................
3.1 3 START AND STOP ADDRESSES 3-11
............................
3.1 4 WAVEFORM PARAMETERS 3-11
............
3.1 4.1 Waveform Frequency, Period, and Sample Freq 3-11
3.1 4.2 External Reference
................................ 3-12
3.1 4.3 Waveform Amplitude
.......................... ... 3-12
............................
3.1 4.4 Waveform Offset ... 3-12
................................
3.1 5 OPERATIONAL MODES 3-12
3.1 5.1 Continuous Mode
............................... . . 3-12
......................................
3.1 5.2 Triggered Mode 3-12
3.15.3 Gated Mode
............................. ........ 3-12
.........................................
3.1 5.4 Toggled Mode 3-12
..... 3.15.5 Burst Mode ....................... . . 3-1 3
....
3.16 SETTING AND CLEARING BREAK POINTS ........... 3-13
.............................
3.1 7 SYNC ADDRESS AND PHASE 3-13
......
3.1 8 STORllVG AND RECALLING WAVEFORMS ....... 3-13
3.19 CHAINED OPERATION
............................... 3-13
................................
3.20 WAVEFORM COUNTER 3-13
..................................
3.21 WAVEFORM HOLD 3-13
....................................
3.22 RETURN TO START 3-13
................................
3.23 LOW BATTERY INDICATOR 3-14
3.24 SERIES OPERATION
...............................
. 3-14
3.25 PARALLEL OPERATION
.................... ... 3-14
.....................
3.26 GPlB CONTROLS (Option 001 Only) 3-15
...........................
3.26.1 GPlB Address DIP Switches 3-15
.........................................
3.26.2 Setup Menu Key 3-15
.........................................
3.26.3 BLIFFR Soft Key 3-15
........................................
3.26.4 ADRS Soft Key 3-15
.....................................
3.26.5 LOCAL Soft Key 3-15
.........................................
3.26.6 Control Knob 3-15
.................
3.27 GENERAL PLIRPOSE INTERFACE BUS (GPIB) 3-16
.................................
3.27.1 Bus Line Definitions 3-17
...................................
3.27.2 Handshake Sequence 3-18
..........................................
3.27.3 Commands 3-18
........................................
3.27.4 Listen Address 3-18
............................................
3.27.5 Talk Address 3-18
.................... ..... ...
3.27.6 Secondary Address .. .. 3-18
....................................
3.27.7 Universal Commands 3-18
Scans by ArtekMedia O 2006