Wavetronix SmartSensor HD - Page 64

Chapter 6: Configuring Lanes
•
63
Setting Description Details
Save To File & Load
From File
Let you save lane
configuration
information to a file on
your computer, and
then load from that
file back to SSMHD.
Use these if you’re
replacing an old HD
with a new one and
don’t want to do the
whole configuration
process again. You
can save from the
old sensor, put up
the new one, and
load it with the lane
information.
Restart Auto Cfg Begins the automatic
configuration process
over.
N/A
Reset Alignment Begins the alignment
check process over.
N/A
Note. This only saves
lane configuration
settings to file. Saving
all configuration
settings to file is
covered in the Tools
chapter of this guide.