98
•
SmartSensor HD User Guide
5 Set the destination, which is the address the sensor will push
data to (only valid for HD and Z4 formats). For the HD format,
it’s the 8-bit subnet/16-bit ID, and for the Z4 format it’s a 24-bit
address. Make sure this destination address is unique for the
communications bus in use.
6 If you’d rather just broadcast the pushed data, click the Broad-
cast checkbox to push the data to the broadcast address
(000/65535 for SS125 and 16777215 for Z4).
7 Click OK to finish.
Note. If the HD is
pushing data to a
custom software
application, set
the destination
to 000/00000.
To Next Page
Loading...
