Wecon VD2F-010SA1P - Precautions for Storage and Transportation; Precautions During Installation

Wecon VD2 SA Series Servo Drives Manual (Lite V1.1)
WECON technology Co., Ltd
2
1.2 Precautions for storage and transportation
Please keep and install in the following environment:
✎Places without direct sunlight;
✎Places where the ambient temperature does not exceed product specifications;
✎Places where the relative humidity does not exceed product specifications;
✎Places where condensation will not occur due to rapid changes in temperature;
✎Places free of corrosive gas and flammable gas;
✎Places without combustible materials nearby;
✎Places with less dust, salt and metal powder;
✎Places where there is no splash of water, oil, medicine, etc.;
✎Places where vibration or shock will not affect the product (places that exceed product
specifications);
✎Places that will not be exposed to radiation;
Storage or installation in environments other than the above may cause product failure or
damage:
✎Please use the correct method for handling according to the weight of the product;
✎Do not hold the motor cable or motor shaft for transportation;
✎When operating the servo unit and servo motor, please pay attention to sharp parts such as
the corners of the device.
1.3 Precautions during installation
✎Do not install this product in a place where water will be splashed or in an environment prone
to corrosion;
✎Please be sure to comply with the devices of the installation direction, otherwise it may cause
device failure;
✎When installing, please make sure to keep the specified distance between the servo drive and
the inner surface of the electric cabinet and other machines, otherwise it may cause fire or device
failure;
✎Do not apply excessive impact, otherwise it may cause equipment failure;
✎Do not sit on the product or place heavy objects on it, otherwise it may cause personal injury;
✎Do not use this product near flammable gases and combustibles, otherwise there may be a risk
of electric shock or fire;
✎Do not block the suction and exhaust ports, and do not allow foreign objects to enter the
product, otherwise it may cause device failure or fire due to the aging of internal components.