2 | CFW300
English
Safety Instructions
1.3 PRELIMINARY RECOMMENDATIONS
DANGER!
Always disconnect the main power supply before touching any electrical
component associated to the inverter. Several components can remain charged
with high voltages or remain in movement (fans) even after the AC power is
disconnected or switched off.
Wait at least ten minutes after turning off the input power for the complete
discharge of the power capacitors.
Always connect the grounding point of the inverter to the protection earth (PE).
DANGER!
The XC10 connector does is not USB compatible, therefore, it cannot be
connected to USB ports.
This connector only serves as the interface between the CFW300 frequency
inverter and its accessories.
NOTES!
Frequency Inverter may interfere with other electronic equipment. In order to
reduce these effects, take the precautions recommended in the Chapter 3
INSTALLATION AND CONNECTION on page 9.
Read the user's manual completely before installing or operating the inverter.
Do not perform any withstand voltage test!
If necessary, contact the manufacturer.
ATTENTION!
Electronic boards have components sensitive to electrostatic discharges.
Do not touch directly on components or connectors.
If necessary, first touch the grounding point of the inverter, which must be
connected to the protection earth (PE) or use a proper grounding strap.
To Next Page
Loading...
