WEST P4100 - 9 P6700, P8700 & P4700 Limit Controller - Model Group

1
/
4
-DIN,
1
/
8
-DIN &
1
/
16
- DIN Controllers & Indicators - Product Manual
Page 56 P6100, P8100 & P4100 Model Group 59305, Issue 5 – March 2005
9 P6700, P8700 & P4700 Limit Controller – Model Group
Limit Controllers protect processes that could become hazardous under fault conditions, by
shutting down the process at a preset level. They are available in three sizes: P6700
1
/
16
DIN
Limit Controller (48 x 48mm), P8700
1
/
8
DIN Limit Controller (96 x 48mm) and P4700
1
/
4
DIN
Limit Controller (96 x 96mm).
• High or low trip
• Exceed & relay trip indicators
• RS485 Modbus and ASCII comms
• PV retransmit option
• 5 amp latching limit relay
• 2 Annunciators or process alarms
• Remote reset option
• Configuration via PC
P6700, P8700 & P4700 Limit Controllers - Configuration Mode
This mode is normally used only when the instrument is configured for the first time or when
a major change is made to the controller characteristics. The Configuration Mode parameters
must be set as required before adjusting parameters in Setup Mode, or attempting to use the
instrument in an application.
Entry into the Configuration Mode
CAUTION:
Adjustments to these parameters should only be performed by personnel
competent and authorised to do so.
Configuration is entered from Select Mode
Hold down and press to force the controller into the Select Mode.
then
Press or to navigate to the Configuration Mode option, then press .
Note:
Entry into this mode is security-protected by the Configuration Mode Lock Code. Refer to
the Unlock Code section for more details.
Scrolling through Parameters and Values
Press to scroll through the parameters (parameters are described below).
Note:
Only parameters that are applicable to the hardware options chosen will be displayed.