WEST P4100 - Page 9

1
/
4
-DIN,
1
/
8
-DIN &
1
/
16
- DIN Controllers & Indicators - Product Manual
Page viii 59305, Issue 5 – March 2005
Resetting Limit Outputs & Annunciators ......................................................................65
Using The Reset Key To Reset Limit Outputs & Annunciators ..............................65
Resetting Limit Hold and Exceed Time........................................................................65
To reset the stored Limit Hold and Exceed Time values .........................................65
P6700, P8700 & P4700 Controllers – Serial Communications Parameters.................66
Bit Parameters ........................................................................................................66
Word Parameters ....................................................................................................66
10 P6010 & P8010 Indicator – Model Group .................................................................70
P6010 & P8010 Indicators - Configuration Mode.........................................................70
Entry into the Configuration Mode...........................................................................70
Scrolling through Parameters and Values...............................................................71
Changing Parameter Values ...................................................................................71
P6010 & P8010 Indicators - Setup Mode.....................................................................78
Entry into the Setup Mode.......................................................................................78
Scrolling through Parameters and Values...............................................................78
Changing Parameter Values ...................................................................................78
P6010 & P8010 Indicators - Operator Mode................................................................ 82
Entry into Operator Mode.......................................................................................82
Scrolling through Parameters and Values...............................................................82
Changing Parameter Values ...................................................................................82
1
/
8
Din Indicator Units Display......................................................................................84
Alarm Indications .........................................................................................................84
Resetting Latched Alarm Outputs................................................................................84
Resetting Alarm 1 Active Time, Minimum PV or Maximum PV....................................84
Multi-Point Scaling.......................................................................................................85
Tare Feature................................................................................................................85
P6010 & P8010 Indicators – Serial Communications Parameters............................... 86
Bit Parameters ........................................................................................................86
Word Parameters ....................................................................................................87
11 Manual Tuning of Controllers...................................................................................90
Controllers Fitted With Primary Output Only................................................................90
Controllers Fitted With Primary and Secondary Outputs .............................................91
Manual Fine Tuning.....................................................................................................91
12 Modbus Serial Communications ..............................................................................93