Wirepath WPS-300-DVR - Page 34

34
WPS-300-DVR-9CH & 16CH Installation and Users Manual
Functions in the Sub-menu:
 •DURATION
Set the length of time the buzzer and the corresponding Alarm Out relay will remain triggered once video
loss is detected for this camera. The Buzzer and Alarm Out relay will reset immediately once video signal
is restored. Press +/- buttons to adjust the value from 3 seconds to 60 minutes or ‘-‘ for indenite requiring
an Alarm Reset.
 •CAMERATOGO
The Camera To Go setting will specify which PTZ camera will go to a predened preset when video loss
is detected for this camera. This feature is used in a system that includes PTZ cameras since the Camera
To Go must be a PTZ camera.
•GOTOPRESET
The GOTO Preset feature works in conjunction with the Camera To Go setting and denes the
preset position the Camera To Go PTZ camera will go to when video signal is lost for this camera.
For more details about preset positions for PTZ cameras, refer to Section 7.
 •PRE-RECORD
Pre-Record denes how much time the DVR will record before video loss is detected. The Pre Record FPS
set in Section 6.2 determines the frame rate of this recording. Press +/- buttons on the front panel of the
DVR or the remote control to adjust the value from 0 to 10 seconds. Alternatively use the mouse to adjust
this setting.
Notethattheactualpre-recordtimemaybeshorterthanthevaluesetifthetotalsizeofthepre-record
  videoexceedsthepre-recordvideobuffer.
 •POST-RECORD
Dene how much time the DVR will record after motion is detected. The Post Record FPS set in Section
6.2 determines the frame rate of this recording. Press +/- buttons on the front panel of the DVR or on the
remote control to adjust the value from 0 to 60 minutes. Alternatively use the mouse to adjust this setting.
 •ALARMOUT
Dene which Alarm Output will be triggered when video loss for this camera is detected. Press +/-
buttons to select N/A for none one of the available Alarm Outputs.
 •DETECTION
See 6.2.2.1 Detection Settings for detail on the available settings.
 •BUZZER
By default, the internal buzzer is enabled to sound when video loss for the camera is detected.
Highlight this setting and press ENTER or +/- to enable or disable this item. Alternatively use the mouse
to left-click on this item.
• LOG
By default, the DVR will log when video loss is detected to the Event Log (see Section 8.2). Highlight
this setting and press ENTER or +/- to enable or disable this item. Alternatively you can use the mouse
by left clicking in the box next to Buzzer in the current dialog window.
 •SCREENMESSAGE
By default, the DVR will display a video loss message in the System Status Bar when video loss is detected
for this camera. Highlight this setting and press ENTER or +/- to enable or disable this item. Alternatively
use the mouse to left-click on this item.
 •E-MAIL
This DVR can send an email message to a predened email address in the event video loss is detected
for this camera. Highlight this setting and press ENTER or +/- to enable or disable this item. Alternatively
use the mouse to left-click on this item. The default setting is disabled. See Section 6.11.1 for more
information on e-mail.
 •FTP
This DVR can send the recorded video loss event for this camera to a FTP server. Highlight this setting
and press ENTER or +/- to enable or disable this item. Alternatively use the mouse to left-click on this
item. The default setting is disabled.