Wirepath WPS-300-DVR - Page 51

51
WPS-300-DVR-9CH & 16CH Installation and Users Manual
Thefollowingisabriefdescriptionforeachiteminthismenuanditsspecicoperations:
Press ENTER or +/- on the front panel of the DVR or on the remote control to check or uncheck each item.
Alternatively use the mouse to enable or disable each item.
 •MonitorChannel1-8
Select Channels (cameras) the user can monitor.
 •X2
Allows the user to zoom live and playback video.
 •PTZ
Allows the user to access PTZ features if supported by the camera.
 •VOLUME
Allows the user to change volume.
 •VIDEOADJUSTMENT
Allows the user to adjust the video
 •VGADISPLAY
Allow the user to change VGA settings.
 •PLAYBACK
Allows the user to view playback video and audio.
 •BACKUP
Allows the user to backup video and audio.
 •CONFIGURATIONBACKUP/RESTORE
Allows the user to backup or restore the DVR conguration.
 •SETUPCAMERA
Allows the user access to Camera Setup.
 •SETUPALARM
Allows the user access to Alarm Setup.
 •SETUPSEQDISPLAY
Allows the user access to Sequence Display setup.
 •SETUPSCHEDULEDRECORD
Allows the user access to Scheduled Record setup.
 •SETUPHDD
Allows the user access to Hard Drive setup.
 •SETUPPASSWORD
Allows the user access to Password Setup.
 •SETUPSYSTEM
Allows the user access to System Setup.
 •SETUPRS-232/422/485
Allows the user access to RS-485 setup.
 •SETUPNETWORK
Allows the user access to Network Setup.
 •SETUPFACTORYDEFAULTS
Allows the user to restore factory defaults to all setup related congurations.
 •SOFTWAREUPGRADE
Allows the user upgrade the DVR software.
 •SHUTDOWN
Allows the user to Shutdown the DVR.