2 Chameleon in GN50
NOTE!
For Chameleon running software 2.4.3 and installed in a GN50, please make sure that the GN50/GT11 is upgraded
to SW version 2.3.
Most of the functionality of software 2.4.3 will be possible to access while running earlier SW versions in GN50, but
new functionality added in later software versions for Chameleon is only possible to manage via the System UI if
the GN50 is upgraded to SW2.3. Functionalities not supported via the System UI can still be managed when
connected directly to the management IP address of the Chameleon.
For more information about this SW version for GN50, and for access to the SW2.3 file, please refer to Documents
at the wisiconnect.tv portal.
To Next Page
Loading...
