A machine reboot may be required, depending on the settings. If prompted, reboot
the machine.
Enabling WSD at a workstation
1. Enter the IP address of the machine.
2. From the Properties tab, select Connectivity.
3. Select Protocols.
4. Select WSD.
5. Select the Enabled checkboxes to enable the services.
6. Select Apply and then select Reboot Machine.
7. Select OK to confirm the reboot.
Printing a Configuration Report
To confirm that the WSD port is set up correctly, print a configuration report.
1. Log in as the System Administrator.
2. Press the Machine Status button
3. Select Machine Information.
4. Select Printer Reports.
5. Select Copy Reports.
6. Select Configuration Report.
7. Press the Start button.
The Configuration Report prints.
8. Select Close until you get to the Machine Information tab.
9. Log off as the administrator.
Configuring Scan Service Settings
1. Select System Settings > Scan Service Settings.
2. Select your preferences from the following options:
• Screen Defaults
• Scan Defaults
• Scan to PC Defaults
• Original Size Defaults
• Output Size Defaults
• Reduce/Enlarge Presets
• Preset Buttons
• Other Settings
7-17Xerox
®
Color J75 Press
System Administration Guide
Using the Scan Service
To Next Page
Loading...
