Xerox CopyCentre/WorkCentre 118 User Guide 117
8 Paper and Other Media
The machine is designed to use a variety of paper types and other media. This chapter
provides information about loading paper and other types of media into the machine.
Loading Paper
This section provides information on how to load paper into trays.
NOTE: Make sure the side and rear paper guides on the trays are properly positioned
to match the size of paper loaded. If there is a gap between the paper stack and the
guides, paper may not be fed to the machine properly, or paper jams may occur.
For information on configurable paper sizes and media types for each tray, refer to
Supported Paper Sizes on page 121 and Supported Paper Types on page 123.
For information on the acceptable range of paper sizes and capacity for each tray, refer
to Paper Supply in the Specifications chapter on page 207.
Preparing Paper for Loading
Before loading paper into the paper trays, fan the edges. This procedure separates any
sheets of paper that are stuck together and reduces the possibility of paper jams.
NOTE: To avoid paper jams and misfeeds, do not remove paper from its packaging
until required.
Loading Paper into the Paper Trays
Depending on the machine configuration, up to four paper trays will be available
excluding Tray 5 (bypass tray).
NOTE: If the machine is processing a job, do not open the active paper tray.
1. Pull out the paper tray towards you.
To Next Page
Loading...
Need help?
General