Common Settings
Xerox CopyCentre/WorkCentre 118 User Guide 129
Machine Ready
Specify whether to activate the tone when the machine becomes ready for operations.
Notification
Specify whether to activate the tone before the machine restores the initial status.
Low Toner Alert
Specify whether to activate the tone when the machine nearly runs out of toner.
Alert
Specify whether to activate the tone when a problem occurs such as a paper jam, toner
shortage, or fax transmission error.
Line Monitor
Specify whether to activate the tone when a Line Monitor is in use. A Line Monitor
allows you to hear call and response signals when connecting to a destination.
We recommended that you select [Enabled] when using On-hook dialing. Refer to On-
Hook in the Fax chapter on page 81.
Notification Tone
Use this feature to cause the machine to display a message before entering the Low
Power Mode or clearing the settings.
Auto Clear
Displays a message before the machine clears the settings.
Low Power Mode
Displays a message before the machine enters the Low Power Mode.
Duration
The machine displays a message the selected period of time before entering the Low
Power Mode or clearing the settings. Select the time within the range from 1 to 10
seconds. You can specify the time to display a message when [Auto Clear] or [Low
Power Mode] is set to [ON].
Auto Repeat
Use this feature to set the machine to automatically repeat button presses after
continuing to press the button for a specified period of time. This reduces the number
of times you will need to press the button. When [On] is selected, specify [Repeat Start]
or [Repeat Interval].
To Next Page
Loading...
Need help?
General