General Procedures and Information
Phaser 3435 5/08 6-37
GP 5 System Set-up
This chapter provides step by step information on setting up the printer.This chapter includes:
• Using control panel menus
• Menu overview
• Printing a demo page
• Changing the display language
• Using toner save mode
Using control panel menus
A number of menus are available to make it easy for to change the printer settings. The diagram
shows the menus and all of the menu items available in each menu.
Accessing control panel menus
The printer can be controlled from the control panel. The control panel menus can be set while the
printer is in use.
1. Press Menu until the valid menu appears on the bottom line of the display and press OK.
2. Press the Scroll buttons until the desired menu item appears and press OK.
3. If the menu item has sub menus, repeat step 2.
4. Press the Scroll buttons to access the desired setting option or the required value.
5. Press OK to save the selection. An asterisk (*) appears next to the selection on the display,
indicating that it is now the default.
6. Press Stop to return to Standby mode. After 60 seconds of inactivity (no key being pressed),
the printer automatically returns to Standby mode.
Menu overview
The control panel menus are used to configure the printer. The control panel provides access to
the following menus:
To Next Page
Loading...
