Xerox WorkCentre 3119

Status Indicator RAPs
2-6 07/06 WorkCentre 3119
5. Check the following parts:
• Cassette assembly, PL 9
• Paper guides, PL 4
• Spring-ETC TR, PL 4
5. Adjust or install new parts as necessary:
• Guide paper, PL 4
• IPR-Plate, PL 9
• RPR-Friction Pad, PL 9
• Cassette assembly, PL 9
6. If the paper feeds into the machine and
Jam 0 occurs, perform ‘Feed Sen Test’ in
Engine Test Mode, GP 4 to check the feed
sensor.
Note: The feed sensor is mounted on the
SMPS/HVPS, PL 1.
6. Install new parts as necessary:
• Feed sensor actuator, PL 4
• SMPS/HVPS, PL 1
• Main PBA, PL 1
7. Check the motor operation using Engine
Test Mode, GP 4. Check the motor harness
and connectors, PL 1 and stepper motor
(drive), PL 6.
7. Install new parts as necessary.
• Motor harness, PL 1
• Drive assembly, PL 6
• Main PBA, PL 1
Check and Cause Solution