Xerox WorkCentre 4150

January 2016
8-3
WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/
ACC 1, ACC 2
Accessories
ACC 1 Foreign Device Interface PWB Checkout
Procedure
Go to the 03-500, 510, 520, 558, 559 Foreign Device Interface Fault RAP.
ACC 2 Foreign Device Interface Installation
Procedure
Go to the relevant procedure:
• 4150 Install
• 4250/4260/4265 Install
4150 Install
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
CAUTION
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
Installing the Foreign Device Interface
1. Unpack the components of the foreign device interface kit.
2. If necessary, disconnect the finisher harness and the network cable.
3. If necessary, remove the fax module, PL 1.10 Item 14.
NOTE: Leave the fax cable connected to the fax module.
4. Remove the infill cover, PL 1.10 Item 19.
5. Carefully remove the foreign device interface push-out from the infill cover, Figure 1.
Figure 1 Push-out removal
6. Remove the rear cover, PL 28.10 Item 6.
1
Remove the push-out.