January 2016
4-175
WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/
REP 12.7
Repairs and Adjustments
REP 12.7 Ejector Assembly and Support Finger Assembly
Parts List on PL 12.25 and PL 12.40
Purpose
This procedure is used to repair the following components:
NOTE: Only perform the steps that are necessary to repair the damaged component.
• Ejector assembly, PL 12.40 Item 16.
• Support Finger Assembly, PL 12.25 Item 20.
• Support Finger Motor, PL 12.25 Item 2.
• Ejector Motor, PL 12.40 Item 1.
Removal
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
CAUTION
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
1. Remove the Front Jogger Assembly and Rear Jogger Assembly, REP 12.5.
2. Remove the Left Cover, refer to REP 12.2.
3. Prepare to remove the Ejector Assembly and Support Finger assembly (Figure 1)
Figure 1 Preparing to Remove the Ejector Assembly and Support Finger Assembly
1
Remove 1 screw.
3
Lower the Finisher PWB.
2
Remove 1 screw.
To Next Page
Loading...
Need help?
General
