Xerox WorkCentre 4150

January 2016
8-6
WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/
ACC 2
Accessories
Figure 6 Harness install
9. Reinstall the infill cover.
10. Reinstall the rear cover.
11. If necessary, reinstall the fax module.
12. If necessary, reinstall the network cable and the finisher harness.
13. Go to Enabling the Foreign Device Interface.
Enabling the Foreign Device Interface
1. Switch on the machine.
2. Enter System Admin Tools, GP 4.
3. Press the Machine Status key.
4. Select the Tools tab.
5. Select ‘Accounting’.
6. Select ‘Authentication Mode’.
7. Under Foreign Device Interface, select ‘On’.
8. Select ‘Save’.
9. Select ‘Foreign Interface Device Setup’.
10. Correctly setup the foreign device interface.
11. Exit System Admin Tools.
CN24