Xerox WORKCENTRE 7425

Troubleshooting
WorkCentre 7425/7428/7435
User Guide
194
Printing Takes Too Long
Printer Resets or Turns Off Frequently
Probable Causes Solutions
The printer is set to a slower printing mode (for
example, heavyweight stock or transparency).
It takes more time to print with special media. When
using regular paper, make sure that the media type is
set properly in the driver and at the printer’s control
panel.
The printer is in ENERGY SAVE mode. It takes time for printing to start in power saving
mode.
The job is very complex. Wait. No action needed.
Probable Causes Solutions
The power cord is not correctly plugged into the
outlet.
Turn off the printer, confirm that the power cord is
correctly plugged into the printer and the outlet, then
turn on the printer.
A system error occurred. Contact your local Xerox service representative with
the error information. Check the error history. For
more information see
Fault Messages on page 192.