Copying
WorkCentre 7425/7428/7435
User Guide
98
2-Sided Book Copying
This feature allows you to make 2-Sided copies of facing pages of the original bound document.
Note: This feature and Book Copying on page 97 cannot be activated simultaneously.
Note: You must use the document glass to make copies from books, magazines, or pamphlets. Do
not place bound originals in the document feeder.
Note: Non-standard size documents will not be separated into two pages accurately.
To copy pages from a book or other bound document:
1. Touch Copy on the touch screen, then touch the Layout Adjustment tab.
2. Touch 2-Sided Book Copying. In the next screen, touch On.
3. Starting & Ending Page specifies the copy start page and copy end page.
•For Starting Page: touch Left Page or Right Page
•For Ending Page: touch Left Page or Right Page
4. Touch Save.
Specifying the Original Size
To specify the original size so that the correct area is copied:
1. Touch Copy on the touch screen, then touch the Layout Adjustment tab.
2. Touch Original Size.
a. The printer can pre-scan the first page of the originals to determine the area to copy. Touch
Auto Detect.
b. If the area to be copied matches a particular paper size, touch Manual Size Input. then touch
the desired paper size. If necessary, touch the scroll arrows to view the entire list.
c. To create a custom size, touch Custom Size at the top of the Standard Sizes list. Touch the up
or down arrow to specify the length and width of the scan area.
d. If the original contains pages of different sizes, touch Mixed Size Originals.
3. Touch Save.
Erasing the Edges of Copy Documents
You can erase content from the edges of your copies by specifying the amount to erase on the right,
left, top, and bottom edges.
To erase edges on copies:
1. Touch Copy on the touch screen, then touch the Layout Adjustment tab.
2. Touch Edge Erase.
3. To erase all of the edges by the same amount:
a. Touch All Edges.
b. Touch the up or down arrow to specify the amount to erase from all edges on Side 1.
To Next Page
Loading...
Need help?
General
