Xerox WorkCentre Pro 423 - Page 206

WorkCentre Pro 423/428 2-174 CHAPTER 2 TROUBLESHOOTING
03/02 How to use the Diagnostic C/E Mode
Chain Functio
n
Item Min. value Default Max. value Amount
of change
Adjustment Remarks
50 120 Country code for the multinational use 00
00:JAPAN(JPN) 04:GERMANY(FRG)
09:AUSTRALIA(AUS) 0A:AUSTRIA(AUT)
0F:BELGIUM(BEL) 16:BRAZIL(BRA)
20:CANADA(CAN) 31:DENMARK(DEN)
3C:FINLAND(FIN) 3D:FRANCE(FRA)
46:GREECE(GRE) 50:HONGKONG(HNG)
54:INDONESIA(INA) 57:IRELAND(IRL)
59:ITALY(ITA) 61:KOREA(KOR) 6C:MALYSIA(MAL)
73:MEXICO(MEX) 7B:HOLLAND(HOL) 7E:NEW
ZEALAND(NZL) 82:NORWAY(NOR)
89:PHILIPPINES(PHI) 8B:PORTUGAL(POR)
9C:SINGAPORE(SIN) A0:SPAIN(ESP)
A5:SWEDEN(SWE) A6:SWIZERLAND(SUI)
A9:THAILAND(THA) B4:UK(GBR) B5:UNITED
STATES(USA) BC:VIETNUM F0:TAIWAN FF:CEE
50 121 Switching of A4-Size Fast Scan Width on FX Machine 0 00 1 1 0: A4 width 1:Letter width
50 122 Dual Access Function
During transmission or reception, the next transmission or
copy operation can be specified.
0 01 1 1 0:dual access disabled 1: dual access enabled
50 123 Version and ID of Division Management Card 10 VVVVIIII VVVV:1 to 9 IIII:0 to 6
50 124 Large-Memory size 0A 1 to 10Mbytes
50 125 The board type cannot be detected automatically at power
on. The XP board is interfaced. This may also be set by
CE.
0 01 1 1 0:SCSI I/F 1:LAN I/F
50 126 Validation of Backup Battery
(Validation from DRAM refresh status at power on)
0 00 1 1 0:disabled 1:enabled
50 127 Printer Job Priority
When a printer job activation request is received from DC-
SYS, the printer job priority set in system data is compared
with the priority of ppb connected to the ready link. If the
printer job priority is higher, the printer job is activated and
other activation requests are rejected.
0 11 FFH 1 0 to FFH(FFH:Top Priority)
50 128 OCT enabled/disabled at printing(receive printing/report
printing/check printing)
0 01 1 1 0:OCT disabled 1:OCT enabled
50 131 Enable/Disable Communication Order Change from Panel 0 01 1 1 0: Disable 1: Enable
50 132 Enable/Disable Print Order Change from Panel 0 01 1 1 0: Disable 1: Enable