03/02 Contents
WorkCentre Pro 423/428 6-21 CHAPTER 6 GENERAL
Install the CRU.
14. Pull out the R/H Unit to the right, and open the Front Right Cover. (Figure-13)
(Figure-13) john6413
15. Install the CRU. (Figure-14)
1) Take the CRU out of the packaging material and shake several times horizontally.
2) Push in the CRU securely.
Note If the Front Right Cover is closed without the CRU handle being latched,
damage of the Right Cover or the Drum Cover on the CRU will result.
3) Pull off the toner seal. (Pull it off when the CRU handle is latched.)
(Figure-14) john6514
Loading paper
16. Load paper. (Figure-15)
Load each tray with paper.
l Tray 1 A4 (LEF)
l Tray 2 B4
l Tray 3 A3
Changing the tray paper size
l Adjust the End Paper Guide and Side Paper Guide of the tray to match the desired paper
size. (Paper size is shown at the bottom of the tray.)
(Figure-15) j0hn6515
17. Set up the size label.(Figure-16)
l Set up the size label of the tray based on the paper loaded.
(Figure-16) j0hn6516
To Next Page
Loading...
