WorkCentre Pro 423/428 8-14 CHAPTER 8 ACCESSORIES
03/02 8.6 Duplex Unit Kit
5. Install the Label. (Figure-3)
(Figure-3) j0hn8021
6. Push in the R/H Unit.
7. Connect the power cord and turn on the power.
8. Check whether Duplex is installed.
1) Enter C/E Mode.
2) Set the Chain/Function code "50/10" and press the Start button.
3) Check that the set value is 1.
4) Exit C/E Mode.
9. Check the following of IIT display.
[DADF uninstalled]
- "2 Sided" is displayed.
[DADF installed]
- When "2 Sided" is selected, "1•2 sided”, "2•2 sided” and "2•1 s ided” are
displayed.
10. Check the Duplex operation.
11. Explain to the key operator how to use Duplex.
To Next Page
Loading...
