Xerox WorkCentre Pro 423 - Page 490

03/02 8.6 Duplex Unit Kit
WorkCentre Pro 423/428 8-13 CHAPTER 8 ACCESSORIES
8.6 Duplex Unit Kit
8.6.1
Product Outline
This kit copies two document sheets on both sides of a single sheet.
When installing this kit on DocuCentre230/280, the following kits are necessary.
Prepare the kits and install them at installation.
(1) Electronic Sort Kit(Product Code: EL200127)(8.3)
(2) Offset Output Kit (Product Code: EL200126)(8.4)
8.6.2 Product Code
Duplex Unit Kit: EL200124
8.6.3 Installation Procedure
1. Check the accessories. (Figure-1)
1) Duplex Assembly………… 1
2) Label…………………….… 1
3) Screw……………………… 1
(Figure-1) j0hn8019
2. Turn the main unit power off.
On printer or Fax-equipped machines, ensure that outstanding jobs have cleared
before servicing or interrupting the power to the machine as follows:.
• FAX equipped machines: Ensure that the “Job in Memory” indicator on the control
panel goes out. Press “Job Status:Stop” button and confirm that the job has cleared
from the “Current Jobs” folder.
• Printer machines: Ensure that “Ready to print or fax” is indicated on the printer
control panel.
WARNING
Switch off the machine and disconnect the power cord.
3. Pull out the R/H Unit.
4. Install the Duplex Assembly. (Figure-2)
1) Install the Duplex Assembly.
2) Tighten the screw.
3) Connect the Connector.
(Figure-2) j0hn8020