WorkCentre Pro 423/428 8-12 CHAPTER 8 ACCESSORIES
03/02 8.5 MSI Kit
(Figure-4) j0hn8017
7. Install the Rear Cover. (Figure-5)
1) Install the Rear Cover.
2) Tighten the screw (silver).
(Figure-5) j0hn8018
8. Connect the power cord and turn on the power.
9. Check whether the MSI is installed.
1) Enter C/E Mode.
2) Set the Chain/Function "50/6" and press the Start button.
3) Check that the set value is 1.
4) Exit C/E Mode.
10. Correct the play of the Side Guide.
1) Set the Side Guide to the Min. width position.
2) Set Chain/Function “20/5” and press the Start button.
3) Select “Save” and press the Start button.
4) Press the Start button again.
5) Set the Side Guide to the Max. width position.
6) Set Chain/Function “20/6” and press the Start button.
7) Select “Save” and press the Start button.
8) Press the Start button again.
9) Exit C/E Mode.
11. Ensure that the “Bypass Tray” is displayed on IIT display.
12. Store the Blind Cover removed in Step 3.
13. Check the MSI operation.
14. Explain to the key operator how to use MSI.
To Next Page
Loading...
