Xerox WorkCentre Pro 423 - Page 488

03/02 8.5 MSI Kit
WorkCentre Pro 423/428 8-11 CHAPTER 8 ACCESSORIES
8.5 MSI Kit
8.5.1
Product Code
MSI Kit: EL200123(FX)
: EL200204 (DMO-E)
8.5.2 Installation Procedure
1. Check the accessories. (Figure-1)
1) MSI Assembly……….…… 1
2) Rear Cover……….………. 1
3) Damper…………………… 1
4) Screw(silver)……………... 1
5) Screw(black)……………… 2
6) Tapping Screw……………. 1
(Figure-1) j0hn8014
2. Turn the main unit power off.
On printer or Fax-equipped machines, ensure that outstanding jobs have cleared
before servicing or interrupting the power to the machine as follows:.
• FAX equipped machines: Ensure that the “Job in Memory” indicator on the control
panel goes out. Press “Job Status:Stop” button and confirm that the job has cleared
from the “Current Jobs” folder.
• Printer machines: Ensure that “Ready to print or fax” is indicated on the printer
control panel.
WARNING
Switch off the machine and disconnect the power cord.
3. Remove the Blind Cover. (Figure-2)
1) Remove the screws (2).
2) Remove the Blind Cover.
(Figure-2) j0hn8015
4. Using the screws (2) removed in step 3, secure the OCT Cover.
5. Install the MSI Assembly. (Figure-3)
1) Install the MSI Assembly.
2) Tighten the Tapping Screw.
3) Tighten the Screws (black)(2).
(Figure-3) j0hn8016
6. Connect the Connectors (3) and install the Damper. (Figure-4)
1) Connect the Connectors (3).
2) Install the Damper.