WorkCentre Pro 423/428 8-10 CHAPTER 8 ACCESSORIES
03/02 8.4 Offset Output Kit
7. Return the R/H Lower Cover to the original position.
8. Push in the R/H Unit.
9. Install the Holder and Paper Weight. (Figure-5)
1) Install the Holder.
2) Install the Paper Weight.
(Figure-5) j0hn8086
10. Connect the power cord and turn on the power.
11. Check whether the OCT is installed.
1) Enter C/E Mode.
2) Set the Chain/Function code "50/11" and press the Start button.
3) Check that the set value is 1.
4) Exit C/E Mode.
12. Check that the Offset operates normally.
13. Explain to the key operator how to use Offset function.
To Next Page
Loading...
