Xilinx HW-130 - Page 11

HW-130 Programmer User Guide ix
Contents
Device Checksum (Options Menu)......................................... 3-5
Diagnostics (Options Menu) ................................................... 3-6
Exit (File Menu)....................................................................... 3-7
Load Master (Options Menu).................................................. 3-7
Lot Summary (File Menu) ....................................................... 3-8
Open File (File Menu)............................................................. 3-8
Profile (File Menu) .................................................................. 3-8
Program Device (Options Menu) ............................................ 3-8
Reset Programmer (Options Menu)........................................ 3-9
Save RAM to File (File Menu)................................................. 3-9
Save Settings (File Menu) ...................................................... 3-9
Select Device (File Menu)....................................................... 3-10
Signature String (Options Menu) ............................................ 3-10
Sound (Options Menu)............................................................ 3-10
Verify Device (Options Menu)................................................. 3-10
Appendix A Keyboard Reference
Keyboard Commands .................................................................. A-1
Quick-Key Reference................................................................... A-2
Appendix B Diagnostics Procedures
Auto-Calibration ........................................................................... B-1
Diagnostics .................................................................................. B-3
RS-232 Serial Communications Test...................................... B-4
Memory Test........................................................................... B-5
Pin Driver Clock Test.............................................................. B-5
Programmable Supply Voltage Loop...................................... B-5
Appendix C Automation
Selecting the Autohandler Mode.................................................. C-1
Programmer Operation ................................................................ C-2
Appendix D Wiring Conventions
Power Cord.................................................................................. D-1
Serial Connector .......................................................................... D-2