HW-130 Programmer User Guide
1-2 Xilinx Development System
● DOS Version 3.3 or higher (DOS installations only)
● Windows 95 or Windows NT or Windows 3.1x (Windows
installations only)
● RS-232 serial port
● 495 KB conventional memory (DOS only)
● 2 MB of hard disk space available
● Serial mouse (recommended)
The HW-130 Programmer software controls the HW-130 Programmer
from the keyboard or the mouse. See Appendix A for a summary of
keyboard quick keys.
Workstation Installations
If you have a workstation, ensure your system meets the following
system requirements.
● 6 MB of hard disk space available
● DB25 or DB9 serial port with read and write permissions
● X-based Windows Manager (X11R5 or higher)
● Operating System:
The HW-130 Programmer software controls the HW-130 Programmer
from the keyboard or the mouse. See Appendix A for a summary of
keyboard quick keys.
Hardware Installation
This section explains how to install and configure the HW-130
Programmer.
SunOS: SunOS 4.1.3 or higher
Solaris: SunOS 5.3 or higher (Solaris 2.3 or higher)
HP9000/700: HP-UX 09.05 or higher
IBM RS6000: AIX 3.2.5.0 or higher
To Next Page