HW-130 Programmer User Guide
1-12 Xilinx Development System
3. To manually copy the files to your current directory, enter the
following tar command at the command line:
No further setup is required for the software.
Starting the Program
After finishing the installation, start the program as follows:
1. Launch the X-based Windows Manager (e.g. OpenLook,
OpenWindows or Motif Window Manager) on your system if it is
not already running.
Note: The HW-130 software has a graphical interface and requires an
X-based Windows Manager.
2. Connect the programmer to the serial port of the workstation and
to the power supply of the programmer.
3. Turn on the power switch at the back of the HW-130 Programmer.
4. Change directory to the install_dir (the directory where the
software was installed) and type the following at the command
line:
hw130 &
Note: If the software cannot establish communication with the
programmer, a message is displayed and indicates possible reasons
for the communication failure.
The HW-130 screen is displayed. It consists of a menu bar and
toolbar buttons. The toolbar buttons allow you to interface
directly with the programmer operations.
Sun OS: tar xvf/cdrom/sn2/hw130
Solaris: tar xvf/cdrom/sol/hw130
or
Note: Vold (Volume Management Deamon) might
have mounted the CD-ROM to ‘/cdrom/hw130’ or
‘/cdrom/cdrom0’ in which case you should run
‘tar xvf /cdrom/hw130/sol/hw130’ or
‘tar xvf /cdrom/cdrom0/sol/hw130’
HP: tar xvf /cdrom/hp7/hw130
IBM: tar xvf /cdrom/rs6/hw130
To Next Page