HW-130 Programmer User Guide 3-1
Chapter 3
Command Reference
This chapter presents the commands available for the HW-130
Programmer. The commands are listed in alphabetical order. When
applicable, the corresponding toolbar button is included in the
command description.
Menus
The HW-130 Programmer has three menus, which are described in
the following sections.
File Menu
The File menu contains commands to select the device type and the
design file. It also includes commands to create files, save the
programmer settings, set the profile, and exit the program.
To access the File menu with the keyboard on a PC, press the letter F,
underlined in the menu name, while holding down the Alt key. Press
the underlined letter corresponding to the menu option you want.
The commands on the File menu are the following:
Select Device Selects a device type.
Open File Opens a design file.
Save RAM to File Saves the contents of the programmer
memory to a file.
Append Data Adds a file to another file.
Save Settings Saves the programmer communications
port and baud rate settings.
and sound options.
Profile Loads an existing profile, creates or
deletes a profile.
Lot Summary Prints lot specific information.
To Next Page
Loading...
